Welcome to the challenge with you of Module five.
In this video, you will be faced with one modification challenge where you will be able to use your
knowledge and skills from this module to modify the 3D object.
I will first describe the challenge and tell you the tools required to complete it.
You will then be able to pause the video and try it out for yourself.
I will then demonstrate how to go about it.
Now, let's get to our modification challenge.
In this all in one modification challenge, you will be required to complete four distinct steps.
However, before you get started with this, you will need to create Esaminato.
The dimensions for the cylinder do not matter.
Once you've created your cylinder, your first step will be to shell the cylinder, making sure it's
hollow and the walls are 5mm thick.
You will then need to use the fillet and chamfered tools to fillet the top outer edge of the cylinder
and chamfered the bottom edge.
Once you've done that, you will then create a splint and use this line to horizontally split cylinder
into two parts.
The fourth and final step will be to draw a square on a plane and use that square to split the outer
face of one of those hubs.
Plus, the video now and try this challenge.
Now that you've tried the challenge yourself.
Let's go through it step by step.
You can see on my screen, I have already created my cylinder, so I will first shell it.
So I will click on the Shell tool and select this top face here, which gives me this.
Now I can use the wall to drag it in.
However, I know my measurement, which is 5mm, so I will take four five and hit enter.
So now I've been able to show my cylinder, my next step will be to fill the top outer edge so fully
and then click on this edge.
I can just drag it to whatever I want.
That's 3.5.
Find it OK.
I will then turn for the bottom months.
Go to modify and click on Channel four, select this edge here and drag it in to transfer.
Four mm looks good.
So I would think, OK.
So we're done with the second step of this challenge, the third step is to create a hotline and speed
the cylinder into two parts.
I will create this plane on the.
Seen here.
Let's just use the Fit Points line.
And that should work.
I will now click on Finish sketch.
I will then head over to modify and click on Split Body.
I can also do it here.
Firstly, I will click on this body here and then my splitting tool, which is blind.
So our line is cutting through this body, and I will say, OK.
So now we have to define what is.
Now, the final commandment to use is this good faith one.
And for that, I would first create a square.
On this plane.
So let's say 12 by 12 and hit, OK.
A look of unfinished sketch.
And then I will head over to modify and click on split face.
I will first let my face, which is this face and then the splitting tool, which is the square.
Now notice that this face goes all the way around and hence my square will be seen on that side as well
as this side.
So now if I click OK, you can see I have my square here and another one here.
So that is it for Module five.
Congratulations, if you go through that challenge.
We are now done with the modification once you once you are ready.
Feel free to proceed to the next module where we begin looking at assemblies infusion 360.
See you there!